Filter By
Filter By
Home
Filter By
74ALS Series
$3.25
(tax excl.)
SN74ALS1244AN
Buffers & Line Drivers Octal Buffer/Driver With 3-State Outputs
20 Pin DIP Package
BALLY / MIDWAY
$43.95
(tax excl.)
Tron & Discs of Tron Optical Encoder PCB
New reproduction of original design. Direct fit, no modifications needed.
PCB is slightly smaller than original. IC's are socketed for easy replacment.
Replaces Midway PN...
Edge Connectors
$4.23
(tax excl.)
18/36 Pin Edge Connector SEC
This size connector is commonly used on many games such as Konami and a lot of bootleg boards.
74ALS Series
$0.90
(tax excl.)
74ALS273
Octal D-Type Positive-Edge-Triggered Flip-Flops with clear
20 Pin DIP Package
Processors & 40 pin ICs
$7.95
(tax excl.)
Z80 DMA
PN Z8410B1
Direct Memory Access Controller
40 Pin DIP Package
Used on some Nintendo boards
Edge Connectors
$2.45
(tax excl.)
10/20 Pin Edge Connector SEC
This size connector is commonly used on Atari games and others as well.
TWA Repro Mfg.
$39.95
(tax excl.)
Reproduction Nintendo audio amp pcb used on sanyo monitors.
No modifications needed, installs exactly like original. Modern look with that classis Nintendo sound.
Replace your old failing amp or just keep one around...
Fusible Resistors
$0.65
(tax excl.)
Nintendo Audio Amp R383 Resistor.
39 Ohm 1/4 watt fusible axial resistor.
Always check this resistor if your having problems with the sound amp on your Sanyo monitor!
Monitor components
$28.65
(tax excl.)
Sanyo 20EZ Remote Pot Kit.
This kit relocates the five pots from the rear of the monitor to a remote board. The remote board includes a detatchable 3 foot cable and can be mounted for easy access to the pots without...
Monitor components
$39.75
(tax excl.)
Reproduction Electrohome GO7-CBO 19" neck board.
Easy to replace that cracked neckboard by simply soldering a few wires. These pcb's are stronger than the original one and are more resistant to cracking. Uses...
Edge Connectors
$4.75
(tax excl.)
50/100 Solder Tail edge connector
PCB mounted, used on games such as professor pacman, gorf, wizard of wor and other midway card rack boards. *Note: the ram card on most of these games are narrow so you would have to...
Home
$4.80
(tax excl.)
Jamma adapter PCB
Build your own Jamma adapter quick and easy by adding jumper wires to connect the pins.
Based off the popular JammaBoards JB-3 adapter.
Includes a spot for a 4 pin .100 header to use for Aux...