Filter By
Filter By
Home
Filter By
Edge Connectors
$4.23
(tax excl.)
18/36 Pin Edge Connector SEC
This size connector is commonly used on many games such as Konami and a lot of bootleg boards.
Tools & Supplies
$5.95
(tax excl.)
Economy 5 inch Flush Cutter Pliers. Cuts up to 1mm Copper and other soft wires. 48 HRC Hardness.These are an absolute must-have in any electronics toolbox! Handle color may vary.
Processors & 40 pin ICs
$7.95
(tax excl.)
Z80 DMA
PN Z8410B1
Direct Memory Access Controller
40 Pin DIP Package
Used on some Nintendo boards
Edge Connectors
$2.45
(tax excl.)
10/20 Pin Edge Connector SEC
This size connector is commonly used on Atari games and others as well.
TWA Repro Mfg.
$39.95
(tax excl.)
Reproduction Nintendo audio amp pcb used on sanyo monitors.
No modifications needed, installs exactly like original. Modern look with that classis Nintendo sound.
Replace your old failing amp or just keep one around...
Fusible Resistors
$0.65
(tax excl.)
Nintendo Audio Amp R383 Resistor.
39 Ohm 1/4 watt fusible axial resistor.
Always check this resistor if your having problems with the sound amp on your Sanyo monitor!
Monitor components
$28.65
(tax excl.)
Sanyo 20EZ Remote Pot Kit.
This kit relocates the five pots from the rear of the monitor to a remote board. The remote board includes a detatchable 3 foot cable and can be mounted for easy access to the pots without...
Tools & Supplies
$4.19
(tax excl.)
Nylon bristle scratch brush.
Similar to the fiberglass brush but is less abrasive.
*Note: not refillable.
Tools & Supplies
$2.75
(tax excl.)
Quality aluminum handle hobby knife.
Uses standard Xacto replacment blades.
Includes blade cover and 5 extra blades.
Edge Connectors
$4.75
(tax excl.)
50/100 Solder Tail edge connector
PCB mounted, used on games such as professor pacman, gorf, wizard of wor and other midway card rack boards. *Note: the ram card on most of these games are narrow so you would have to...