Filter By
Filter By
Arcade Parts
Filter By
GAL & PAL
$1.50
(tax excl.)
GAL16V8
High Performance E2CMOS PLD Generic Array Logic
20 Pin DIP Package
Factory excess parts. Programmed once, never installed. Like new.
Fusible Resistors
$0.65
(tax excl.)
Nintendo Audio Amp R383 Resistor.
39 Ohm 1/4 watt fusible axial resistor.
Always check this resistor if your having problems with the sound amp on your Sanyo monitor!
GAL & PAL
$0.65
(tax excl.)
PALCE20V8
Flash Erasable, Reprogrammable CMOS Programmable Array Logic
24 Pin DIP Package
Edge Connectors
$4.23
(tax excl.)
18/36 Pin Edge Connector SEC
This size connector is commonly used on many games such as Konami and a lot of bootleg boards.
Other Parts
$9.75
(tax excl.)
Ms Pacman Aux Board Ribbon Cable New 40 pin Ribbon Cable Gold contacts Approx 11-12" to replace original.
Edge Connectors
$2.45
(tax excl.)
10/20 Pin Edge Connector SEC
This size connector is commonly used on Atari games and others as well.
Other Parts
$1.50
(tax excl.)
6 Pack of Nylon cable ties to secure the Sync Bus and Vram cards to Pac or Mspac pcb.
Crystals
$0.90
(tax excl.)
Crystal 18.432 MhzHC-49 PackageUsed on Pacman and many other arcade pcb's
Buttons & Switches
$4.79
(tax excl.)
Bally / Midway Reset pushbutton Direct replacment for reset pushbuttons used on many Bally/Midway boards including Pacman, Ms Pacman, Galaxian, Bally pinball, Williams system 3-6 mpu, etc.
Buttons & Switches
$1.15
(tax excl.)
Dip Switch -8 Position 16 Pin DIP Package
Just about every arcade pcb will have at least one of these on it.