Filter By
Filter By
Arcade Parts
Filter By
GAL & PAL
$1.50
(tax excl.)
GAL16V8
High Performance E2CMOS PLD Generic Array Logic
20 Pin DIP Package
Factory excess parts. Programmed once, never installed. Like new.
Fusible Resistors
$0.65
(tax excl.)
Nintendo Audio Amp R383 Resistor.
39 Ohm 1/4 watt fusible axial resistor.
Always check this resistor if your having problems with the sound amp on your Sanyo monitor!
GAL & PAL
$0.65
(tax excl.)
PALCE20V8
Flash Erasable, Reprogrammable CMOS Programmable Array Logic
24 Pin DIP Package
Other Parts
$9.75
(tax excl.)
Ms Pacman Aux Board Ribbon Cable New 40 pin Ribbon Cable Gold contacts Approx 11-12" to replace original.
Other Parts
$1.50
(tax excl.)
6 Pack of Nylon cable ties to secure the Sync Bus and Vram cards to Pac or Mspac pcb.
Crystals
$0.90
(tax excl.)
Crystal 18.432 MhzHC-49 PackageUsed on Pacman and many other arcade pcb's
Buttons & Switches
$4.79
(tax excl.)
Bally / Midway Reset pushbutton Direct replacment for reset pushbuttons used on many Bally/Midway boards including Pacman, Ms Pacman, Galaxian, Bally pinball, Williams system 3-6 mpu, etc.
Buttons & Switches
$1.15
(tax excl.)
Dip Switch -8 Position 16 Pin DIP Package
Just about every arcade pcb will have at least one of these on it.
Other Parts
$12.95
(tax excl.)
MsPacman Aux board mounting bracket.
This bracket mounts to the cab just to the right of the main pcb. It holds the aux board which is connected to the main board with a ribbon cable.
These are original used parts....